For Petrol, Diesel and LPG engines. Use one 1 litre can for 4 litres of engine capacity or 10% RESTORE by volume to engine oil. This quantity of Engine Restorer will treat 4-5 litres of engine capacity.
Note: remetalisers are not suited for VVT Vanos or HEUI engines. Call for more advice.
Otherwise RESTORE efficiently restores compression, engine power, life and reduces oil and fuel consumption. By filling in scratches and restoring the friction-producing metal in the engine, Engine Restorer has the ability to quickly and inexpensively cure issues including:
- Blue Smoke and Exhaust Emissions i.e. MOT Emissions Fail ?
- Low Compression as in can't climb hills?
- High Oil Consumption as in piston blow-by
- Reduced Horsepower and Torque as in hard to cold start
- Hydraulic Tappet Noise (not for manually adjusted tappets) as in scratched Hydraulic Lifters
- Declining fuel economy and MPG as in an engine with unbalanced compression
- Stubborn hot and cold starts as in metal on metal wear surfaces have degraded over time
- Fledgling bottom end knock as in internal coolant or water leakage diluting the oil
Add Engine Restorer to clean oil in a clean engine and drive for at least 1000 miles to complete the repair. Leave the product in the engine until the next oil change for continued improvement and protection against friction and wear!
Ametech® Engine RESTORE Oil is a life-saver for worn, tired and smoky engines and will balance out compression across the cylinders even in newer engines. RESTORE reduces engine noise and has even been known to cure fledgling bottom-end knock. All used engines, but particularly those that have clocked up more than 40,000 miles, will benefit from the use of RESTORE - after treatment you will notice less smoke, less oil-burn, fewer start-up problems and the engine will run smoother and quieter. You could save a fortune in engine repairs and replacement parts and keep your car running longer and more reliably.
Used in accordance with instructions Ametech® Engine RESTORE Oil has the ability to:
- Cure Blue Smoke and exhaust emissions
- Restore Compression
- Reduce Oil Consumption
- Restore Horsepower and Torque
- Improve MPG
- Improve cold starting ability
- Prolong Engine Life
- Contribute towards reducing Global Warming by reducing CO emissions and extending the useable life of old engines
- Repair fishing boat engines and tractor engines without any downtime.
An EP (extreme pressure) lubricant in its own right, Ametech® Engine RESTORE Oil just needs a standard motor oil to act as a carrier for it in your engine - not friction reducing oils containing plant esters (such as Castrol Magnatec or racing formulas such as Silkolene 'R'), as are formulated to polarise metals and will just repel RESTORE's CSL™ particles, preventing them from reaching the worn metalwork in the engine. RESTORE can also be used in MANUAL gearboxes, where it is helpful in reducing whine by reversing wear in the bronze bearings and reducing 'back-lash' by re-aligning the gears. Do not use RESTORE in automatic gearboxes; we have another product called Metal-Tec10™ which reduces friction and heat in automatic gearboxes, smoothing out the metal and reducing whine.
Ametech® Engine RESTORE Oil is suitable for use in all four stroke petrol and diesel engines, with the exception of HEUI engines (hydraulically actuated electronic unit injection diesel engines), VVT-Li engines (VVT Lift-intelligent), and other engines using oil pressure to actuate Variable Valve Timing (VVT), such as Toyota VVTi, Honda VTec and iVTec engines, BMW Vanos and Double or Dual Vanos, Subaru ACVS systems etc.; all these engines utilise the engine oil pressure to actuate other engine functions and often do not tolerate particles in oil.
RESTORE is safe to use in standard dual-fuelled and lpg engines, most standard (mechanical) VVT engines and engines with turbo-chargers and catalytic converters. RESTORE should not be used in wet clutch environments or in a Petroil mix. (Please read our FREQUENTLY ASKED QUESTIONS for more information on use of RESTORE in different types of engines and situations).
One Litre can of RESTORE will treat up to 4-5 litres of engine capacity or 10 litres of oil in the sump. The rules of thumb for working out the correct dosage for a first-time treatment in your engine are: 200-250ml Ametech Engine RESTORE Oil per litre of engine size (cc); 10% RESTORE by volume to engine oil. Order multiples of this size of can for each 5000cc of engine size you wish to treat. For repeat treatments use half the initial dosage or 5% RESTORE by volume to engine oil. For best results, add to a clean engine with fresh oil and filter. Just shake it up and pour it in! Comprehensive instructions are provided with every purchase.
This size of can has a resealable stopper and is therefor more suitable where repeat doses will be needed over a period of time. It is important to shake the can well before using to agitate the CSL™ particles.